Bootloader
~~~~~~~~~~
-Depending on whether the system is booted in EFI or legacy BIOS mode the
-{pve} installer sets up either `grub` or `systemd-boot` as main bootloader.
-See the chapter on xref:sysboot[{pve} host bootladers] for details.
+{pve} uses xref:sysboot_proxmox_boot_tool[`proxmox-boot-tool`] to manage the
+bootloader configuration.
+See the chapter on xref:sysboot[{pve} host bootloaders] for details.
ZFS Administration
.Changing a failed bootable device
-Depending on how {pve} was installed it is either using `grub` or `systemd-boot`
-as bootloader (see xref:sysboot[Host Bootloader]).
+Depending on how {pve} was installed it is either using `proxmox-boot-tool`
+footnote:[Systems installed with {pve} 6.4 or later, EFI systems installed with
+{pve} 5.4 or later] or plain `grub` as bootloader (see
+xref:sysboot[Host Bootloader]). You can check by running:
+
+----
+# proxmox-boot-tool status
+----
The first steps of copying the partition table, reissuing GUIDs and replacing
the ZFS partition are the same. To make the system bootable from the new disk,
NOTE: Use the `zpool status -v` command to monitor how far the resilvering
process of the new disk has progressed.
-.With `systemd-boot`:
+.With `proxmox-boot-tool`:
----
-# pve-efiboot-tool format <new disk's ESP>
-# pve-efiboot-tool init <new disk's ESP>
+# proxmox-boot-tool format <new disk's ESP>
+# proxmox-boot-tool init <new disk's ESP>
----
NOTE: `ESP` stands for EFI System Partition, which is setup as partition #2 on
bootable disks setup by the {pve} installer since version 5.4. For details, see
-xref:sysboot_systemd_boot_setup[Setting up a new partition for use as synced ESP].
+xref:sysboot_proxmox_boot_setup[Setting up a new partition for use as synced ESP].
.With `grub`:
----
To activate the daemon it is necessary to edit `/etc/zfs/zed.d/zed.rc` with your
-favourite editor, and uncomment the `ZED_EMAIL_ADDR` setting:
+favorite editor, and uncomment the `ZED_EMAIL_ADDR` setting:
--------
ZED_EMAIL_ADDR="root"
We strongly recommend to use enough memory, so that you normally do not
run into low memory situations. Should you need or want to add swap, it is
-preferred to create a partition on a physical disk and use it as swapdevice.
+preferred to create a partition on a physical disk and use it as a swap device.
You can leave some space free for this purpose in the advanced options of the
installer. Additionally, you can lower the
``swappiness'' value. A good value for servers is 10: