UefiCpuPkg/MpInitLib: Prepare SEV-ES guest APs for OS use

UefiCpuPkg/MpInitLib: Prepare SEV-ES guest APs for OS use

BZ: https://bugzilla.tianocore.org/show_bug.cgi?id=2198

Before UEFI transfers control to the OS, it must park the AP. This is
done using the AsmRelocateApLoop function to transition into 32-bit
non-paging mode. For an SEV-ES guest, a few additional things must be
done:
  - AsmRelocateApLoop must be updated to support SEV-ES. This means
    performing a VMGEXIT AP Reset Hold instead of an MWAIT or HLT loop.
  - Since the AP must transition to real mode, a small routine is copied
    to the WakeupBuffer area. Since the WakeupBuffer will be used by
    the AP during OS booting, it must be placed in reserved memory.
    Additionally, the AP stack must be located where it can be accessed
    in real mode.
  - Once the AP is in real mode it will transfer control to the
    destination specified by the OS in the SEV-ES AP Jump Table. The
    SEV-ES AP Jump Table address is saved by the hypervisor for the OS
    using the GHCB VMGEXIT AP Jump Table exit code.

Cc: Eric Dong <eric.dong@intel.com>
Cc: Ray Ni <ray.ni@intel.com>
Cc: Laszlo Ersek <lersek@redhat.com>
Reviewed-by: Eric Dong <eric.dong@intel.com>
Signed-off-by: Tom Lendacky <thomas.lendacky@amd.com>
Regression-tested-by: Laszlo Ersek <lersek@redhat.com>