debian/changelog

   1 ifupdown2 (1.2.1) UNRELEASED; urgency=medium
   2
   3   * Fix: Link down does not work on any intf configured in a VRF
   4   * Add: warning when bridge attribute are used on non br[port] intf
   5   * Add: point-to-point protocol (ppp) addon to create/configure ppp interfaces
   6   * Add: tunnel support (gretap, ipip, sit, vti, ip6gre, ipip6, ip6ip6, vti6)
   7   * Add:  0/1/on/off/yes/no support to ip[6]-forward attribute
   8   * addressvirtual module_globals "addressvirtual_with_route_metric" policy
   9
  10  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 31 Aug 2018 23:42:42 +0200
  11
  12 ifupdown2 (1.2.0) UNRELEASED; urgency=medium
  13
  14   * Package architecture refactoring and cleanups
  15   * Package can be build/install as debian, pip or rpm package
  16   * Makefile to easily perform tasks (i.e.: install, build, test, upload..)
  17   * VRF slaves: add support for link-down yes
  18   * addressvirtual: macvlan: add default metric to ip4 and ip6
  19   * Closes #48: Run up/down on "manual" interfaces, but ignore any errors.
  20   * Closes #58: address addon "vlan_aware_bridge_address_support" policy
  21   * Traditional bridge support for mstpctl attr: (portautoedge, portrestrrole)
  22   * Configuration for IPv6 link-local auto-generate mode, new attributes:
  23         ipv6-addrgen (address addon)
  24         address-virtual-ipv6-addrgen (addressvirtual addon)
  25
  26  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 25 Jun 2018 23:42:42 +0200
  27
  28 ifupdown2 (1.1.18) RELEASED; urgency=medium
  29
  30   * Fix: Link down does not work on SVI configured in a VRF
  31   * Fix: ifreload causes MTU to drop on bridge SVIs
  32   * Fix: addons: addressvirtual: check if SVI name is first in routing table
  33   * Fix: ifreload error on deleting bond slaves from an already configured bond
  34   * Fix: ifupdown2 error is confusing when netmask is specified for vxlan-local-tunnelip
  35   * Fix: ifupdown2 syntax check needed for vxlan interfaces
  36   * Fix: vxlan-ageing default timer doesn't align with bridge-ageing
  37   * Fix: Error with "ifreload -a -n" when MGMT VRF is not Applied
  38   * Fix: using reserved VLAN range reports error but ifreload returns 0
  39   * Fix: unable to set bridge-portmcrouter to "2"
  40   * Fix: vxlan syntax-check warn on missing vxlan-local-tunnelip
  41   * Fix: traditional bridge svi breaks when extra bridge added
  42   * Fix: github #39: addons: vrf: fix vrf slave link kind
  43   * New. Enabled: addons: vxlan: add support for vxlan-port attribute
  44
  45  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 12 Apr 2018 11:10:04 +0200
  46
  47 ifupdown2 (1.1.17) RELEASED; urgency=medium
  48
  49   * Fix: ip[6]-forward attributes not set at boot
  50
  51  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 08 Feb 2018 09:48:37 +0100
  52
  53 ifupdown2 (1.1.16) RELEASED; urgency=medium
  54
  55   * Fix: python exception on macvlans address dump
  56   * Fix: eth0 doesn't acquire DHCP address when mgmt VRF is enabled
  57
  58  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 09 Jan 2018 02:02:58 +0100
  59
  60 ifupdown2 (1.1.15) RELEASED; urgency=medium
  61
  62   * New. Enabled: bridge: add support for bridge-l2protocol-tunnel
  63   * New. Enabled: bridge attributes, when removed reset to default
  64   * New. Enabled: vxlan attributes, when removed reset to default
  65   * New. Enabled: improve handling of optional resources (if missing bridge-utils/ethtool)
  66   * Fix: policy "iface_defaults" not supported for MTU
  67   * Fix: address module: handling of ipv4 & ipv6 (add/remove)
  68   * Fix: warning for vlan reserved range
  69   * Fix: MTU handling on bridge SVIs
  70
  71  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 22 Nov 2017 19:07:43 +0100
  72
  73 ifupdown2 (1.1.14) RELEASED; urgency=medium
  74
  75   * New. Enabled: default policy for bridge MAC address
  76   * Fix: ethtool: don't set link speed and duplex if autoneg is on
  77
  78  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 25 Oct 2017 23:12:27 +0200
  79
  80 ifupdown2 (1.1.13) RELEASED; urgency=medium
  81
  82   * Fix: VRF: ssh session not killed on ifreload
  83
  84  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 15 Sep 2017 22:43:12 +0200
  85
  86 ifupdown2 (1.1.12) RELEASED; urgency=medium
  87
  88   * New. Enabled: mpls-enable attribute
  89   * New. Enabled: bond and bridge module moved to netlink configuration
  90   * New. Enabled: handle a mix of auto and specified vrf table ids
  91   * Fix: igmp attribute reset to defaults when removed from config
  92
  93  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 07 Aug 2017 22:14:03 +0200
  94
  95 ifupdown2 (1.1.11) RELEASED; urgency=medium
  96
  97   * Fix: link-down attribute not applied on slave ports
  98   * Fix: bug that prevented config of mtu below 1280
  99
 100  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 18 May 2017 12:45:21 -0700
 101
 102 ifupdown2 (1.1.10) RELEASED; urgency=medium
 103
 104   * New. Enabled: drop the dependency to pkg_resources, hardcode version number (closes: #855401)
 105   * New. Enabled: adjust allow-hotplug behavior to ifupdown (closes: #855598)
 106   * New. Enabled: bond-lacp-rate support slow/fast argument
 107   * New. Enabled: ifquery --syntax-help: add support for json output
 108   * New. Enabled: vlan: add new attribute 'vlan-protocol'
 109   * New. Enabled: address: add new attribute 'ip6-forward'
 110   * New. Enabled: bridge: add new attribute 'bridge-mcstats'
 111   * New. Enabled: bridge: add new attribute 'bridge-vlan-stats'
 112   * New. Enabled: bridge: add new attribute 'bridge-vlan-protocol'
 113   * New. Enabled: bridge: add new attribute 'bridge-arp-nd-suppress'
 114   * Fix: bond: add attribute bond-(up|down)delay
 115   * Fix: bridge-vids: --syntax-check accepts legacy syntax
 116
 117  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 17 Apr 2017 06:18:04 +0200
 118
 119 ifupdown2 (1.1.9) RELEASED; urgency=medium
 120
 121   * New. Enabled: support for bridge-learning attribute
 122
 123  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 06 Feb 2017 13:22:51 -0800
 124
 125 ifupdown2 (1.1.8) RELEASED; urgency=medium
 126
 127   * New. Enabled: update link-speed values: add 25G and 50G
 128   * New. Enabled: new 'link-down' [yes|no] attribute to keep link down
 129
 130  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 17 Jan 2017 08:39:29 +0100
 131
 132 ifupdown2 (1.1.7) RELEASED; urgency=medium
 133
 134   * New. Enabled: fix for inet and inet6 dhcp on the same interface
 135   * New. Enabled: syntax check to warn on common configuration mistakes
 136   * New. Enabled: addons: bridge: disable ip fwding on a bridge with no ip
 137     and no upperifaces
 138   * Fix: fixes for MTU handling
 139   * Fix: dhcpv6 fails if interface doesn't have link-local addr
 140
 141  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 07 Dec 2016 05:48:45 +0100
 142
 143 ifupdown2 (1.1.6) RELEASED; urgency=medium
 144
 145   * Closes: github #14. add environment variables passed to user scripts
 146   * New. Enabled: addons may provide a list of ifupdown scripts to ignore
 147
 148  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 19 Sep 2016 16:37:36 -0700
 149
 150 ifupdown2 (1.1.5) RELEASED; urgency=medium
 151
 152   * Fix: handling of EXISTS errors on address add
 153   * Fix: handling of mtu on addressvirtual macvlan devices
 154   * Fix: mako namespace handling
 155
 156  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 16 Sep 2016 12:48:04 -0700
 157
 158 ifupdown2 (1.1.4) RELEASED; urgency=medium
 159
 160   * Performance improvements
 161   * New. Enabled: sbin: start-networking: support hotplug class from init script
 162   * New. Enabled: support for classical numerical bond modes
 163   * New. Enabled: extend ifquery support for mstpctl addons
 164   * New. Enabled: each addon may perform semantic and syntax checks by
 165     implementing a custom method
 166   * Fix: Support for address-virtual lines under a vrf slave
 167   * Fix: Defaults for link attributes were not applied
 168   * Fix: Disable IPv6 duplicate address detection on VRR interfaces
 169   * Fix: ifquery to extract vlan-id from iface if not preset
 170   * Fix: ifquery -c bridge pvid error on a valid config
 171
 172  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 29 Jul 2016 08:55:50 -0700
 173
 174 ifupdown2 (1.1.3) RELEASED; urgency=medium
 175
 176   * Fix: Interface configuration parsing error when keyword vlan
 177     is the interface name.
 178
 179  -- Julien Fortin <julien@cumulusnetworks.com>  Sun, 05 Jun 2016 08:55:50 -0700
 180
 181 ifupdown2 (1.1.2) RELEASED; urgency=medium
 182
 183   * Fix: checks for invalid address-virtual attributes
 184   * New. Deprecated: `mstpctl-stp` attribute
 185   * New. Deprecated: lacp parameters: bond-ad-sys-priority, bond-ad-sys-mac-addr
 186   * New. Enabled: addon module for configuring vrf
 187   * New. Enabled: bridge: display warning when (in vlan unware bridge)
 188     an untagged bridge is not configured
 189   * New. Enabled: adjusting MTU for vlan devices depending on lower device mtu
 190   * New. Enabled: introduce checks for reserved vrf table names
 191   * New. Enabled: ifquery: new option '--with-defaults' to include default
 192     attributes
 193   * New. Enabled: bridge: disabling ipv6 on bridge if any VXLAN port
 194   * New. Enabled: vrf awareness in dhcp addon module
 195
 196  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 3 May 2016 14:42:42 -0700
 197
 198 ifupdown2 (1.1.0) unstable; urgency=low
 199
 200   * Initial release.
 201
 202  -- Roopa Prabhu <roopa@cumulusnetworks.com>  Thu, 20 Aug 2015 06:14:24 -0700