debian/changelog

   1 ifupdown2 (1.2.1) UNRELEASED; urgency=medium
   2
   3   * Fix: Link down does not work on any intf configured in a VRF
   4   * Add: warning when bridge attribute are used on non br[port] intf
   5   * Add: point-to-point protocol (ppp) addon to create/configure ppp interfaces
   6   * Add: tunnel support (gretap, ipip, sit, vti, ip6gre, ipip6, ip6ip6, vti6)
   7   * Add:  0/1/on/off/yes/no support to ip[6]-forward attribute
   8   * addressvirtual module_globals "addressvirtual_with_route_metric" policy
   9   * Closes: ethtool: link-fec: local variable 'fec_attrs'
  10             referencede before assignment
  11
  12  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 31 Aug 2018 23:42:42 +0200
  13
  14 ifupdown2 (1.2.0) UNRELEASED; urgency=medium
  15
  16   * Package architecture refactoring and cleanups
  17   * Package can be build/install as debian, pip or rpm package
  18   * Makefile to easily perform tasks (i.e.: install, build, test, upload..)
  19   * VRF slaves: add support for link-down yes
  20   * addressvirtual: macvlan: add default metric to ip4 and ip6
  21   * Closes #48: Run up/down on "manual" interfaces, but ignore any errors.
  22   * Closes #58: address addon "vlan_aware_bridge_address_support" policy
  23   * Traditional bridge support for mstpctl attr: (portautoedge, portrestrrole)
  24   * Configuration for IPv6 link-local auto-generate mode, new attributes:
  25         ipv6-addrgen (address addon)
  26         address-virtual-ipv6-addrgen (addressvirtual addon)
  27
  28  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 25 Jun 2018 23:42:42 +0200
  29
  30 ifupdown2 (1.1.18) RELEASED; urgency=medium
  31
  32   * Fix: Link down does not work on SVI configured in a VRF
  33   * Fix: ifreload causes MTU to drop on bridge SVIs
  34   * Fix: addons: addressvirtual: check if SVI name is first in routing table
  35   * Fix: ifreload error on deleting bond slaves from an already configured bond
  36   * Fix: ifupdown2 error is confusing when netmask is specified for vxlan-local-tunnelip
  37   * Fix: ifupdown2 syntax check needed for vxlan interfaces
  38   * Fix: vxlan-ageing default timer doesn't align with bridge-ageing
  39   * Fix: Error with "ifreload -a -n" when MGMT VRF is not Applied
  40   * Fix: using reserved VLAN range reports error but ifreload returns 0
  41   * Fix: unable to set bridge-portmcrouter to "2"
  42   * Fix: vxlan syntax-check warn on missing vxlan-local-tunnelip
  43   * Fix: traditional bridge svi breaks when extra bridge added
  44   * Fix: github #39: addons: vrf: fix vrf slave link kind
  45   * New. Enabled: addons: vxlan: add support for vxlan-port attribute
  46
  47  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 12 Apr 2018 11:10:04 +0200
  48
  49 ifupdown2 (1.1.17) RELEASED; urgency=medium
  50
  51   * Fix: ip[6]-forward attributes not set at boot
  52
  53  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 08 Feb 2018 09:48:37 +0100
  54
  55 ifupdown2 (1.1.16) RELEASED; urgency=medium
  56
  57   * Fix: python exception on macvlans address dump
  58   * Fix: eth0 doesn't acquire DHCP address when mgmt VRF is enabled
  59
  60  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 09 Jan 2018 02:02:58 +0100
  61
  62 ifupdown2 (1.1.15) RELEASED; urgency=medium
  63
  64   * New. Enabled: bridge: add support for bridge-l2protocol-tunnel
  65   * New. Enabled: bridge attributes, when removed reset to default
  66   * New. Enabled: vxlan attributes, when removed reset to default
  67   * New. Enabled: improve handling of optional resources (if missing bridge-utils/ethtool)
  68   * Fix: policy "iface_defaults" not supported for MTU
  69   * Fix: address module: handling of ipv4 & ipv6 (add/remove)
  70   * Fix: warning for vlan reserved range
  71   * Fix: MTU handling on bridge SVIs
  72
  73  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 22 Nov 2017 19:07:43 +0100
  74
  75 ifupdown2 (1.1.14) RELEASED; urgency=medium
  76
  77   * New. Enabled: default policy for bridge MAC address
  78   * Fix: ethtool: don't set link speed and duplex if autoneg is on
  79
  80  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 25 Oct 2017 23:12:27 +0200
  81
  82 ifupdown2 (1.1.13) RELEASED; urgency=medium
  83
  84   * Fix: VRF: ssh session not killed on ifreload
  85
  86  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 15 Sep 2017 22:43:12 +0200
  87
  88 ifupdown2 (1.1.12) RELEASED; urgency=medium
  89
  90   * New. Enabled: mpls-enable attribute
  91   * New. Enabled: bond and bridge module moved to netlink configuration
  92   * New. Enabled: handle a mix of auto and specified vrf table ids
  93   * Fix: igmp attribute reset to defaults when removed from config
  94
  95  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 07 Aug 2017 22:14:03 +0200
  96
  97 ifupdown2 (1.1.11) RELEASED; urgency=medium
  98
  99   * Fix: link-down attribute not applied on slave ports
 100   * Fix: bug that prevented config of mtu below 1280
 101
 102  -- Julien Fortin <julien@cumulusnetworks.com>  Thu, 18 May 2017 12:45:21 -0700
 103
 104 ifupdown2 (1.1.10) RELEASED; urgency=medium
 105
 106   * New. Enabled: drop the dependency to pkg_resources, hardcode version number (closes: #855401)
 107   * New. Enabled: adjust allow-hotplug behavior to ifupdown (closes: #855598)
 108   * New. Enabled: bond-lacp-rate support slow/fast argument
 109   * New. Enabled: ifquery --syntax-help: add support for json output
 110   * New. Enabled: vlan: add new attribute 'vlan-protocol'
 111   * New. Enabled: address: add new attribute 'ip6-forward'
 112   * New. Enabled: bridge: add new attribute 'bridge-mcstats'
 113   * New. Enabled: bridge: add new attribute 'bridge-vlan-stats'
 114   * New. Enabled: bridge: add new attribute 'bridge-vlan-protocol'
 115   * New. Enabled: bridge: add new attribute 'bridge-arp-nd-suppress'
 116   * Fix: bond: add attribute bond-(up|down)delay
 117   * Fix: bridge-vids: --syntax-check accepts legacy syntax
 118
 119  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 17 Apr 2017 06:18:04 +0200
 120
 121 ifupdown2 (1.1.9) RELEASED; urgency=medium
 122
 123   * New. Enabled: support for bridge-learning attribute
 124
 125  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 06 Feb 2017 13:22:51 -0800
 126
 127 ifupdown2 (1.1.8) RELEASED; urgency=medium
 128
 129   * New. Enabled: update link-speed values: add 25G and 50G
 130   * New. Enabled: new 'link-down' [yes|no] attribute to keep link down
 131
 132  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 17 Jan 2017 08:39:29 +0100
 133
 134 ifupdown2 (1.1.7) RELEASED; urgency=medium
 135
 136   * New. Enabled: fix for inet and inet6 dhcp on the same interface
 137   * New. Enabled: syntax check to warn on common configuration mistakes
 138   * New. Enabled: addons: bridge: disable ip fwding on a bridge with no ip
 139     and no upperifaces
 140   * Fix: fixes for MTU handling
 141   * Fix: dhcpv6 fails if interface doesn't have link-local addr
 142
 143  -- Julien Fortin <julien@cumulusnetworks.com>  Wed, 07 Dec 2016 05:48:45 +0100
 144
 145 ifupdown2 (1.1.6) RELEASED; urgency=medium
 146
 147   * Closes: github #14. add environment variables passed to user scripts
 148   * New. Enabled: addons may provide a list of ifupdown scripts to ignore
 149
 150  -- Julien Fortin <julien@cumulusnetworks.com>  Mon, 19 Sep 2016 16:37:36 -0700
 151
 152 ifupdown2 (1.1.5) RELEASED; urgency=medium
 153
 154   * Fix: handling of EXISTS errors on address add
 155   * Fix: handling of mtu on addressvirtual macvlan devices
 156   * Fix: mako namespace handling
 157
 158  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 16 Sep 2016 12:48:04 -0700
 159
 160 ifupdown2 (1.1.4) RELEASED; urgency=medium
 161
 162   * Performance improvements
 163   * New. Enabled: sbin: start-networking: support hotplug class from init script
 164   * New. Enabled: support for classical numerical bond modes
 165   * New. Enabled: extend ifquery support for mstpctl addons
 166   * New. Enabled: each addon may perform semantic and syntax checks by
 167     implementing a custom method
 168   * Fix: Support for address-virtual lines under a vrf slave
 169   * Fix: Defaults for link attributes were not applied
 170   * Fix: Disable IPv6 duplicate address detection on VRR interfaces
 171   * Fix: ifquery to extract vlan-id from iface if not preset
 172   * Fix: ifquery -c bridge pvid error on a valid config
 173
 174  -- Julien Fortin <julien@cumulusnetworks.com>  Fri, 29 Jul 2016 08:55:50 -0700
 175
 176 ifupdown2 (1.1.3) RELEASED; urgency=medium
 177
 178   * Fix: Interface configuration parsing error when keyword vlan
 179     is the interface name.
 180
 181  -- Julien Fortin <julien@cumulusnetworks.com>  Sun, 05 Jun 2016 08:55:50 -0700
 182
 183 ifupdown2 (1.1.2) RELEASED; urgency=medium
 184
 185   * Fix: checks for invalid address-virtual attributes
 186   * New. Deprecated: `mstpctl-stp` attribute
 187   * New. Deprecated: lacp parameters: bond-ad-sys-priority, bond-ad-sys-mac-addr
 188   * New. Enabled: addon module for configuring vrf
 189   * New. Enabled: bridge: display warning when (in vlan unware bridge)
 190     an untagged bridge is not configured
 191   * New. Enabled: adjusting MTU for vlan devices depending on lower device mtu
 192   * New. Enabled: introduce checks for reserved vrf table names
 193   * New. Enabled: ifquery: new option '--with-defaults' to include default
 194     attributes
 195   * New. Enabled: bridge: disabling ipv6 on bridge if any VXLAN port
 196   * New. Enabled: vrf awareness in dhcp addon module
 197
 198  -- Julien Fortin <julien@cumulusnetworks.com>  Tue, 3 May 2016 14:42:42 -0700
 199
 200 ifupdown2 (1.1.0) unstable; urgency=low
 201
 202   * Initial release.
 203
 204  -- Roopa Prabhu <roopa@cumulusnetworks.com>  Thu, 20 Aug 2015 06:14:24 -0700