+Using the {pve} Installation CD-ROM
+~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
+
+Please insert the installation CD-ROM, then boot from that
+drive. Immediately afterwards you can choose the following menu
+options:
+
+Install Proxmox VE::
+
+Start normal installation.
+
+Install Proxmox VE (Debug mode)::
+
+Start installation in debug mode. It opens a shell console at several
+installation steps, so that you can debug things if something goes
+wrong. Please press `CTRL-D` to exit those debug consoles and continue
+installation. This option is mostly for developers and not meant for
+general use.
+
+Rescue Boot::
+
+This option allows you to boot an existing installation. It searches
+all attached hard disks, and if it finds an existing installation,
+boots directly into that disk using the existing Linux kernel. This
+can be useful if there are problems with the boot block (grub), or the
+BIOS is unable to read the boot block from the disk.
+
+Test Memory::
+
+Runs 'memtest86+'. This is useful to check if your memory if
+functional and error free.
+
+You normally select *Install Proxmox VE* to start the installation.
+After that you get prompted to select the target hard disk(s). The
+`Options` button aside lets you select the target file system, and
+defaults to `ext4`. The installer uses LVM if you select 'ext3',
+'ext4' or 'xfs' as file system, and offers additional option to
+restrict LVM space (see <<advanced_lvm_options,below>>)
+
+If you have more than one disk, you can also use ZFS as file system.
+ZFS supports several software RAID levels, so this is specially useful
+if you do not have a hardware RAID controller. The `Options` button
+lets you select the ZFS RAID level, and you can choose disks there.
+
+The next pages just asks for basic configuration options like time
+zone and keyboard layout. You also need to specify your email address
+and select a superuser password.
+
+The last step is the network configuration. Please note that you can
+use either IPv4 or IPv6 here, but not both. If you want to configure a
+dual stack node, you can easily do that after installation.
+
+If you press `Next` now, installation starts to format disks, and
+copies packages to the target. Please wait until that is finished,
+then reboot the server.
+