qm: small follow-up linking to our virtio wiki page

instead of the direct link to the latest ISO. As the wiki page contains
a bit more details about the VirtIO drivers and can be changed quickly
if needed.

Signed-off-by: Aaron Lauterer <a.lauterer@proxmox.com>

diff --git a/qm.adoc b/qm.adoc
index 711fa3f02d9729bfd7196d6f9c9b933d190f6e48..6615c57d12be69b9794b3ed33b2247edfd57b0bc 100644 (file)
--- a/qm.adoc
+++ b/qm.adoc
@@ -781,14 +781,14 @@ ethtool command:
 where X is the number of the number of vCPUs of the VM.
 
 To configure a Windows guest for Multiqueue install the
-https://fedorapeople.org/groups/virt/virtio-win/direct-downloads/stable-virtio/virtio-win.iso[
-Redhat VirtIO Ethernet Adapter drivers], then adapt the NIC's configuration as
-follows. Open the device manager, right click the NIC under "Network adapters",
-and select "Properties". Then open the "Advanced" tab and select "Receive Side
-Scaling" from the list on the left. Make sure it is set to "Enabled". Next,
-navigate to "Maximum number of RSS Queues" in the list and set it to the number
-of vCPUs of your VM. Once you verified that the settings are correct, click "OK"
-to confirm them.
+https://pve.proxmox.com/wiki/Windows_VirtIO_Drivers[Redhat VirtIO Ethernet
+Adapter drivers], then adapt the NIC's configuration as follows. Open the
+device manager, right click the NIC under "Network adapters", and select
+"Properties". Then open the "Advanced" tab and select "Receive Side Scaling"
+from the list on the left. Make sure it is set to "Enabled". Next, navigate to
+"Maximum number of RSS Queues" in the list and set it to the number of vCPUs of
+your VM. Once you verified that the settings are correct, click "OK" to confirm
+them.
 
 You should note that setting the Multiqueue parameter to a value greater
 than one will increase the CPU load on the host and guest systems as the