+Ceph maintenance
+----------------
+
+Replace OSDs
+~~~~~~~~~~~~
+
+One of the common maintenance tasks in Ceph is to replace a disk of an OSD. If
+a disk is already in a failed state, then you can go ahead and run through the
+steps in xref:pve_ceph_osd_destroy[Destroy OSDs]. Ceph will recreate those
+copies on the remaining OSDs if possible. This rebalancing will start as soon
+as an OSD failure is detected or an OSD was actively stopped.
+
+NOTE: With the default size/min_size (3/2) of a pool, recovery only starts when
+`size + 1` nodes are available. The reason for this is that the Ceph object
+balancer xref:pve_ceph_device_classes[CRUSH] defaults to a full node as
+`failure domain'.
+
+To replace a still functioning disk, on the GUI go through the steps in
+xref:pve_ceph_osd_destroy[Destroy OSDs]. The only addition is to wait until
+the cluster shows 'HEALTH_OK' before stopping the OSD to destroy it.
+
+On the command line use the following commands.
+----
+ceph osd out osd.<id>
+----
+
+You can check with the command below if the OSD can be safely removed.
+----
+ceph osd safe-to-destroy osd.<id>
+----
+
+Once the above check tells you that it is save to remove the OSD, you can
+continue with following commands.
+----
+systemctl stop ceph-osd@<id>.service
+pveceph osd destroy <id>
+----
+
+Replace the old disk with the new one and use the same procedure as described
+in xref:pve_ceph_osd_create[Create OSDs].
+
+Trim/Discard
+~~~~~~~~~~~~
+It is a good measure to run 'fstrim' (discard) regularly on VMs or containers.
+This releases data blocks that the filesystem isn’t using anymore. It reduces
+data usage and resource load. Most modern operating systems issue such discard
+commands to their disks regularly. You only need to ensure that the Virtual
+Machines enable the xref:qm_hard_disk_discard[disk discard option].
+
+[[pveceph_scrub]]
+Scrub & Deep Scrub
+~~~~~~~~~~~~~~~~~~
+Ceph ensures data integrity by 'scrubbing' placement groups. Ceph checks every
+object in a PG for its health. There are two forms of Scrubbing, daily
+cheap metadata checks and weekly deep data checks. The weekly deep scrub reads
+the objects and uses checksums to ensure data integrity. If a running scrub
+interferes with business (performance) needs, you can adjust the time when
+scrubs footnote:[Ceph scrubbing https://docs.ceph.com/docs/{ceph_codename}/rados/configuration/osd-config-ref/#scrubbing]
+are executed.
+
+